installation in Red Hat Linux (D-Link 530TXb)
=============================================
1:mkdir temp
2:cd temp
3:mcopy a:vialinux.tar . (copies from DOS disk to current working directory)
(mcopy is mtools if you don have mtools,you can mount -t /dev/fd0 and use cp command)
4.tar xvf vialinux.tar
5:type
make clean
make all
to generate via-rhine.o && pci-scan.o
6:cp via-rhine.o /lib/modules/2.2.XXX/net/via-rhine.o
cp pci-scan.o /lib/modules/2.2.XXX/net/pci-scan.o
7:linuxconf (run linuxconf)
8:enter setting in the Config/Networking/Client tasks/Basic host information/
IP address: xxx.xxx.xxx.xxx
Netmask: 255.255.255.xxx
Net device: eth0
Kernel module: via-rhine
install in SMP Ret Hat
======================
1:mkdir temp
2:cd temp
3:mcopy a:vialinux.tar . (copies from DOS disk to current working directory)
(mcopy is mtools if you don have mtools,you can mount -t /dev/fd0 and use cp command)
4.tar xvf vialinux.tar
5:type
make clean
make smp
to generate via-rhine.o && pci-scan.o
6:cp via-rhine.o /lib/modules/2.2.XXX/net/via-rhine.o
cp pci-scan.o /lib/modules/2.2.XXX/net/pci-scan.o
7:linuxconf (run linuxconf)
8:enter setting in the Config/Networking/Client tasks/Basic host information/
IP address: xxx.xxx.xxx.xxx
Netmask: 255.255.255.xxx
Net device: eth0
Kernel module: via-rhine
install for Red Hat version less than 6.0:
==========================================
1:vi /etc/conf.modules add following
alias eth0 via-rhine
install via-rhine insmod via-rhine
Can install driver at boot time.
==================================
If you can install your driver using insmod command (please install pci-scan.o
module before via-rhine.o module), but you can install it at boot time, please
check whether the driver is in the correct directory (ex: /lib/modules/2.2.XXX/net/),
and check the /lib/modules/2.2.XXX/modules.dep file, it must include the following
line:
/lib/modules/2.2.XXX/net/via-rhine.o: /lib/modules/2.2.XXX/net/pci-scan.o
You can insert this line using depmod command or insert it manually.发布人:ken 来自: